Installation Guide – Rear Emblem – Seat CUPRA Ateca (Black Carbon LIMITED)

Tools & Materials Needed

Microfiber cloth
 Isopropyl alcohol or adhesive cleaner
Plastic removal tool or dental floss
Heat gun / hairdryer (optional, helps soften old adhesive)
Masking tape
Rubbing alcohol / surface prep wipe

Prepare the Surface

1. Clean the trunk lid surface thoroughly (remove any dirt, wax or grease).

2. Ensure the surface is dry and free from contaminants before applying the emblem.

This ensures the new emblem will bond strongly once installed.

Remove Old Emblem (If Applicable)

If your vehicle already has a rear emblem installed:

1. Warm up the emblem area gently with a heat gun or hairdryer — this softens the original adhesive.

2. Slide dental floss or a thin plastic line behind the emblem and work it back and forth (like sawing motion).

3. Slowly pop the badge off without bending the trunk lid.

Work evenly across the emblem — taking your time prevents paint damage.

Clean Old Adhesive Residue

1. After removing the old emblem, clean off all leftover adhesive using an adhesive remover or isopropyl alcohol.

2. Make sure the surface is perfectly clean and dry.

Prepare the New Emblem

1. Before removing the protective backing, test-fit the Black Carbon LIMITED emblem on the trunk to verify correct positioning.

2. Use masking tape guides to mark the exact placement.

3. Once satisfied, peel back a portion of the adhesive backing.

Install the New Emblem

1. Align the emblem carefully using your tape guides.

2. Press it firmly onto the surface — start from the center and work outward to avoid air pockets.

3. Apply even pressure for about 30–60 seconds to ensure full contact.

The emblem uses pre-applied automotive grade adhesive on the back — no drilling or extra glue needed.

Final Check

• Make sure the emblem is flat and aligned.

• Wipe off any fingerprints or smudges.

Tips for Best Results

 Install at temperatures between 15–25 °C for optimal adhesive performance.
 Avoid washing the car for 24–48 hours after installation to allow the adhesive to cure fully.

Typical Time Needed

Around 10–20 minutes for removal + installation if no heavy adhesive residue.
(Plan extra time if the old emblem is stubborn.)